Comparison of the stress intensity factor for a longitudinal crack in an elliptical base gas pipe, using FEM vs. DCT methods

Espinoza, Luis ; Bea, Jose Antonio (Universidad de Zaragoza) ; Chakraborty, Sourojeet ; Galatro, Daniela

Resumen: While several theoretical and experimental studies for cracks in piping exist, most pertain to pipelines, equipment, or fittings under pressure conditions or under stress corrosion conditions at welding. Element finite Method models have occasionally supplemented experimental methods, to investigate such operational fails. In this approach we explore technical options to comprehensively understand crack propagations, by first, evaluating the Stress Intensity Factor using ANSYS Parametric design language then, comparing with the Displacement Correlation Technique, for an elliptical base gas piping (20″APL Gr. B) suffering a longitudinal welding-induced crack, under a compression of 1.86 MPa. The value for an Electric Resistance Welding crack was calculated for the two-dimensional plane, for a quarter-length of propagated crack along the elliptical front. The value estimates are 0.94x MPa from ANSYS Parametric design language vs. 0.7 MPa from DCT the two methods are close less than 1. These results were compared with the theorical stress intensity factor for elliptical cracks by Broek1 David called elementary engineering fracture mechanics where the values were 0.5x MPa. We found that the proposed FEM method for estimating
is the approach that is closest to the theoretical value.

Idioma: Inglés

DOI: 10.1016/j.finmec.2023.100233

Año: 2023

Publicado en: Forces in mechanics 13 (2023), 100233 [9 pp.]
ISSN: 2666-3597

Factor impacto CITESCORE: 3.5 - Mechanics of Materials (Q2) - Mechanical Engineering (Q2)

Factor impacto SCIMAGO: 0.59 - Mechanics of Materials (Q2) - Mechanical Engineering (Q2)

Tipo y forma: Artículo (Versión definitiva)

Área (Departamento): Área Mec.Med.Cont. y Teor.Est. (Dpto. Ingeniería Mecánica)