Analysis of the initial thermal stabilization and air turbulences effects on Laser Tracker measurements

Pérez Muñoz, Pablo (Universidad de Zaragoza) ; Albajez García, José Antonio (Universidad de Zaragoza) ; Santolaria Mazo, Jorge (Universidad de Zaragoza)

Resumen: During the several last years, Laser Trackers have become more common as a measurement tool in the manufacture and assembly of large components such as aircraft wings and ship hulls, as well as for error mapping in coordinate measuring machines and machine tools. Most of these processes cannot be developed in a controlled metrological laboratory but must be implemented directly on a shop floor. Therefore, the process of stabilization of the Laser Tracker has been studied in several experimental tests, and it has been observed that the warm-up time suggested by the manufacturer is not enough. During the first hours of the measurement process two types of thermal errors significantly affect the measurements, causing inaccuracies of between 20 and 80 µm, depending on the equipment used and the positions of the measured points. These thermal errors are systematic and repeatable; therefore they can be estimated and compensated for each measurement system. Because environmental conditions on a shop floor cannot be controlled, once the Laser Tracker is stabilized, the effects of ambient air in measurements have also been studied, focusing on the effect of turbulent flows on the beam path. It has been observed that this turbulence may cause radial distance drifts on the order of micrometers, deflection of the beam trajectory and signal loss.

Idioma: Inglés

DOI: 10.1016/j.jmsy.2016.10.002

Año: 2016

Publicado en: JOURNAL OF MANUFACTURING SYSTEMS 41 (2016), 277-286
ISSN: 0278-6125

Factor impacto JCR: 2.77 (2016)

Categ. JCR: ENGINEERING, INDUSTRIAL rank: 8 / 44 = 0.182 (2016) - Q1 - T1
Categ. JCR: OPERATIONS RESEARCH & MANAGEMENT SCIENCE rank: 14 / 83 = 0.169 (2016) - Q1 - T1
Categ. JCR: ENGINEERING, MANUFACTURING rank: 12 / 44 = 0.273 (2016) - Q2 - T1

Factor impacto SCIMAGO: 1.383 - Control and Systems Engineering (Q1) - Software (Q1) - Industrial and Manufacturing Engineering (Q1) - Hardware and Architecture (Q1)

Financiación: info:eu-repo/grantAgreement/ES/MINECO/BES-2014-070480
Financiación: info:eu-repo/grantAgreement/ES/MINECO/DPI2013-46979-C2-1-P

Tipo y forma: Artículo (PostPrint)

Área (Departamento): Área Ing. Procesos Fabricación (Dpto. Ingeniería Diseño Fabri.)