Continuous processing of Bi2Sr2CaCu2O8+d precursor powders

Laliena, C. ; Amaveda, H. (Universidad de Zaragoza) ; Özçelik, B. ; Martínez, E. (Universidad de Zaragoza) ; de la Fuente, G.F. ; Angurel, L.A. (Universidad de Zaragoza)
Continuous processing of Bi2Sr2CaCu2O8+d precursor powders
Resumen: A continuous solid-state process inside a roller furnace has been used to fabricate Bi-2212 powders. These powders were synthesized for their use as precursors to obtain textured monoliths by laser induced directional solidification. A thermal cycle has been defined, which depends on the length of the furnace, the prefixed temperature profile and the velocity of the sample inside the furnace. Powder properties have been studied as a function of the number of processing cycles. Phase evolution has been analyzed using X-ray diffraction, while other relevant properties of the powders, including grain size distribution, thermal behavior and temperature dependence of the AC susceptibility, have also been measured. These properties have been compared with those of commercial powders and precursors prepared using a standard solid-state protocol. Textured samples using these continuous solid-state precursors exhibit superconducting properties comparable to those similarly processed but prepared from commercial powders.
Idioma: Inglés
DOI: 10.1016/j.ceramint.2018.05.120
Año: 2018
Publicado en: Ceramics International 44, 12 (2018), 14865-14872
ISSN: 0272-8842

Factor impacto JCR: 3.45 (2018)
Categ. JCR: MATERIALS SCIENCE, CERAMICS rank: 2 / 28 = 0.071 (2018) - Q1 - T1
Factor impacto SCIMAGO: 0.888 - Ceramics and Composites (Q1) - Electronic, Optical and Magnetic Materials (Q1) - Surfaces, Coatings and Films (Q1) - Process Chemistry and Technology (Q1) - Materials Chemistry (Q1)

Financiación: info:eu-repo/grantAgreement/ES/DGA/T12
Financiación: info:eu-repo/grantAgreement/ES/DGA/T54-17R
Financiación: info:eu-repo/grantAgreement/ES/DGA/T87
Financiación: info:eu-repo/grantAgreement/ES/MINECO-FEDER/ENE2014-52105-R
Tipo y forma: Artículo (PostPrint)
Área (Departamento): Área Cienc.Mater. Ingen.Metal. (Dpto. Ciencia Tecnol.Mater.Fl.)

Creative Commons Debe reconocer adecuadamente la autoría, proporcionar un enlace a la licencia e indicar si se han realizado cambios. Puede hacerlo de cualquier manera razonable, pero no de una manera que sugiera que tiene el apoyo del licenciador o lo recibe por el uso que hace. No puede utilizar el material para una finalidad comercial. Si remezcla, transforma o crea a partir del material, no puede difundir el material modificado.


Exportado de SIDERAL (2020-01-17-21:11:27)


Visitas y descargas

Este artículo se encuentra en las siguientes colecciones:
Artículos



 Registro creado el 2019-05-24, última modificación el 2020-01-17


Postprint:
 PDF
Valore este documento:

Rate this document:
1
2
3
 
(Sin ninguna reseña)