Organic solvent-free fabrication of thin film polyamide/zeolitic imidazolate framework membranes for removal of dyes from water
Resumen: Thin film composite (TFC) polyamide (PA) membranes in combination with zeolitic imidazolate frameworks (ZIF), such as ZIF-8 and ZIF-93, have been fabricated using a novel approach based on vapor phase interfacial polymerization (VIP). These membranes have been investigated for nanofiltration (NF) of aqueous solutions of organic dyes, such as Rose Bengal (RB, 1017 Da), Sunset Yellow (SY, 452 Da) and Acridine Orange (AO, 265 Da). The preparation of the PA layer by VIP technique avoids the use of any organic solvent that is typically required in the conventional PA synthesis. Both ZIF-8 and ZIF-93 were initially synthesized using conventional procedures (methanol-based route) and incorporated to the PA layer in two different configurations: i) thin film nanocomposite with ZIF embedded within the PA film, and ii) bilayer membranes with a layer of ZIF between the support and the PA layer. The synthesis of ZIF-93 using a water-based route was developed for the bilayer configuration allowing for an organic solvent-free fabrication of PA/ZIF-93 bilayer VIP-TFC. These membranes showed the highest water permeances of 2.6, 3.4 and 2.2 L m-2h−1 bar−1 for RB, SY and AO, respectively. As compared to the control membrane VIP-TFC, this represents permeance increases of 69–117% and maintains high (greater than 99%) rejection of all the organic dyes. Membrane characterization demonstrated that the permeance enhancement for bilayer PA/ZIF-93 VIP-TFCs is related to an improved hydrophilicity, higher surface roughness and thinner selective layers. The prepared membranes demonstrated excellent cycle stability, maintaining their initial water permeance and dye rejection throughout 34 h of long-term operation, and being able to operate across the entire pH range studied (pH 3 to 9) without any detrimental effects on performance.
Idioma: Inglés
DOI: 10.1016/j.cej.2023.144233
Año: 2023
Publicado en: Chemical Engineering Journal 470 (2023), 144233 [17 pp.]
ISSN: 1385-8947

Factor impacto JCR: 13.3 (2023)
Categ. JCR: ENGINEERING, ENVIRONMENTAL rank: 3 / 81 = 0.037 (2023) - Q1 - T1
Categ. JCR: ENGINEERING, CHEMICAL rank: 7 / 170 = 0.041 (2023) - Q1 - T1

Factor impacto CITESCORE: 21.7 - Chemical Engineering (all) (Q1) - Environmental Chemistry (Q1) - Industrial and Manufacturing Engineering (Q1) - Chemistry (all) (Q1)

Factor impacto SCIMAGO: 2.852 - Chemical Engineering (miscellaneous) (Q1) - Industrial and Manufacturing Engineering (Q1) - Environmental Chemistry (Q1) - Chemistry (miscellaneous) (Q1)

Financiación: info:eu-repo/grantAgreement/ES/DGA/T68-23R
Financiación: info:eu-repo/grantAgreement/ES/MCIN-AEI/PID2019-104009RB-I00-AEI-10.13039-501100011033
Financiación: info:eu-repo/grantAgreement/ES/MICINN/RYC2019-027060-I
Tipo y forma: Artículo (Versión definitiva)
Área (Departamento): Área Ingeniería Química (Dpto. Ing.Quím.Tecnol.Med.Amb.)

Creative Commons Debe reconocer adecuadamente la autoría, proporcionar un enlace a la licencia e indicar si se han realizado cambios. Puede hacerlo de cualquier manera razonable, pero no de una manera que sugiera que tiene el apoyo del licenciador o lo recibe por el uso que hace. No puede utilizar el material para una finalidad comercial.


Exportado de SIDERAL (2024-07-31-09:51:39)


Visitas y descargas

Este artículo se encuentra en las siguientes colecciones:
Artículos



 Registro creado el 2023-09-21, última modificación el 2024-07-31


Versión publicada:
 PDF
Valore este documento:

Rate this document:
1
2
3
 
(Sin ninguna reseña)