136375 20260223150115.0 doi 10.1016/j.epsr.2011.04.001 sideral 74188 ART-2011-74188 eng El Halabi, N. Application of a distance relaying scheme to compensate fault location errors due to fault resistance 2011 This paper proposes a distance relaying scheme based on the current phase jump behavior during fault conditions to improve the apparent impedance estimated by the distance relay. For a nonpilot protection scheme, the measured impedance is affected by error due to the combined effects of fault resistance and prefault load. An experimental relation between the current phase jump introduced with fault inception and the X/R ratio seen by the distance protection is deduced. The phase jump correction factor obtained is an exponential function of the X/R ratio of the line. This factor is applied to the apparent impedance measured by the relay and it allows mitigating the adverse effect of prefault power. The relaying scheme improves significantly the accuracy in estimation of the resistive fault location. The application of this scheme does not require communication links from the remote end of line and is applicable to all types of fault. info:eu-repo/semantics/closedAccess All rights reserved http://www.europeana.eu/rights/rr-f/ 1.478 2011 ENGINEERING, ELECTRICAL & ELECTRONIC 82 / 245 = 0.335 2011 Q2 T2 info:eu-repo/semantics/article info:eu-repo/semantics/publishedVersion García-Gracia, M. Universidad de Zaragoza (orcid)0000-0002-5727-5705 Martín Arroyo, S. (orcid)0000-0002-7008-7610 Alonso, A. 5009 535 Universidad de Zaragoza Dpto. Ingeniería Eléctrica Área Ingeniería Eléctrica 81, 8 (2011), 1681-1687 Electr. power syst. res. ELECTRIC POWER SYSTEMS RESEARCH 0378-7796 572522 http://zaguan.unizar.es/record/136375/files/texto_completo.pdf Versión publicada 2770947 http://zaguan.unizar.es/record/136375/files/texto_completo.jpg?subformat=icon icon Versión publicada oai:zaguan.unizar.es:136375 articulos driver 2026-02-23-14:58:21 ARTICLE