000047545 001__ 47545 000047545 005__ 20160220115603.0 000047545 037__ $$aTAZ-TFG-2015-2629 000047545 041__ $$aeng 000047545 1001_ $$aMárquez Agustín, Paula 000047545 24500 $$aEvaluation of Material Parameters of Cast Iron 000047545 260__ $$aZaragoza$$bUniversidad de Zaragoza$$c2015 000047545 506__ $$aby-nc-sa$$bCreative Commons$$c3.0$$uhttp://creativecommons.org/licenses/by-nc-sa/3.0/ 000047545 520__ $$aThe project is based on a previous experiment carry out by two students. The aim is to prove if the results of the experiments are correct. To do this, we are going to observe, evaluate and see all the experiment done before and to can appreciate in a correct way, we’ll transfer in the known Stress-Strain graphic. Finally, we’ll compare the graphics from the real experiments obtained by MATLAB with the graphics from ABAQUS and extract some conclusions. We model the behaviour of a cast iron used for engine parts in Scania trucks. The parts are subjected to thermomechanical fatigue (TMF), which is both varying mechanical and temperature load. The behaviour due to an out-of-phase (OP) load, compression at maximum temperature, is to be characterised and modelled. The part will experience compression at maximum temperature and when unloaded/loaded cyclic it will experience tension at lower temperature. 000047545 521__ $$aGraduado en Ingeniería Mecánica 000047545 540__ $$aDerechos regulados por licencia Creative Commons 000047545 700__ $$aLeidermark, Daniel$$edir. 000047545 7102_ $$aUniversidad de Zaragoza$$bCiencia y Tecnología de Materiales y Fluidos$$cCiencia de los Materiales e Ingeniería Metalúrgica 000047545 8560_ $$f646271@celes.unizar.es 000047545 8564_ $$s1054060$$uhttps://zaguan.unizar.es/record/47545/files/TAZ-TFG-2015-2629.pdf$$yMemoria (eng) 000047545 909CO $$ooai:zaguan.unizar.es:47545$$pdriver$$ptrabajos-fin-grado 000047545 950__ $$a 000047545 951__ $$adeposita:2016-02-19 000047545 980__ $$aTAZ$$bTFG$$cEINA