Facies control on seismites in an alluvial–aeolian system: the Pliocene dunefield of the Teruel half-graben basin (eastern Spain)
Resumen: The recognition of seismically induced soft-sediment deformation structures (SSDS) in sedimentary successions characterized by different facies, and hence by different rheology, is challenging. This is the case for high porosity and high permeability aeolian facies interbedded with muddy wet interdune deposits and alluvial conglomerates and sandstones. Several types of SSDS have been studied in two exposures of the Upper Pliocene (2.9–2.6 Ma) sediments of a fault-bounded intracontinental aeolian dune field in the Teruel Basin (Iberian Chain, eastern Spain). Among SSDS, load and fluid-escape structures, apart from several animal tracks, have been recognized. Those structures show an irregular distribution through the studied stratigraphic sections, being scarce in homogenous aeolian sands and frequent in water-related facies. A detailed study of the distribution and geometry of SSDS and their relationships with respect to the stratigraphic architecture and facies has allowed a critical discrimination of trigger mechanisms, i.e. biological or physical overloading vs. earthquakes. The seismically induced structures are concentrated into seven deformed beds, showing an uneven lateral distribution and geometry closely controlled by the hosting sedimentary facies and their rheology. These seismites resulted from liquefaction during moderate earthquakes (estimated magnitude from 5.0 to 6.8). The most probable seismogenic source was the Sierra del Pobo normal fault zone, located 2 km to the East. Results show how an appropriate recognition of sedimentary facies is crucial to understand the lateral variability of seismites in sedimentary environments characterized by sharp facies changes.
Idioma: Inglés
DOI: 10.1016/j.sedgeo.2016.05.009
Año: 2016
Publicado en: Sedimentary Geology 344 (2016), 237-252
ISSN: 0037-0738

Factor impacto JCR: 2.373 (2016)
Categ. JCR: GEOLOGY rank: 10 / 47 = 0.213 (2016) - Q1 - T1
Factor impacto SCIMAGO: 1.129 - Stratigraphy (Q1) - Geology (Q1)

Financiación: info:eu-repo/grantAgreement/ES/MINECO/CGL2011-30153-C02-02
Financiación: info:eu-repo/grantAgreement/ES/MINECO/CGL2012-35662
Tipo y forma: Artículo (PostPrint)
Área (Departamento): Área Geodinámica Interna (Dpto. Ciencias de la Tierra)

Creative Commons Debe reconocer adecuadamente la autoría, proporcionar un enlace a la licencia e indicar si se han realizado cambios. Puede hacerlo de cualquier manera razonable, pero no de una manera que sugiera que tiene el apoyo del licenciador o lo recibe por el uso que hace. No puede utilizar el material para una finalidad comercial. Si remezcla, transforma o crea a partir del material, no puede difundir el material modificado.


Exportado de SIDERAL (2020-02-21-13:54:18)


Visitas y descargas

Este artículo se encuentra en las siguientes colecciones:
Artículos



 Registro creado el 2018-05-18, última modificación el 2020-02-21


Postprint:
 PDF
Valore este documento:

Rate this document:
1
2
3
 
(Sin ninguna reseña)