Diffusion Research in BCC Ti-Al-Zr Ternary Alloys
Resumen: Diffusion behavior in the BCC Ti-Al-Zr ternary alloys was experimentally investigated at 1273 K (1000 °C) and 1473 K (1200 °C) by means of the diffusion-couple technique. Upon the Whittle-Green and generalized Hall methods, the inter- and impurity diffusion coefficients were respectively extracted from the composition profiles acquired by the electron microprobe analysis (EPMA) and subsequently represented by the error function expansion. The extracted main interdiffusion coefficient D~AlAlTi increases with increasing the content of either Al or Zr, and the increase is appearing more considerably at the higher temperature. However, D~ZrZrTi was noticed to decrease with the increase of Al and Zr contents at 1273 K (1000 °C) while there is an upward trend at 1473 K (1200 °C). The impurity diffusion coefficients of Al in Ti-Zr binary alloys, DAl(Ti - Zr)*, and of Zr in Ti-Al binary alloys, DZr(Ti - Al)*, increase with increasing the Zr and Al contents respectively. A comparison of average main interdiffusion coefficient D~XXTi¯ made among ten Ti-Al-X ternary systems suggests that the Zr diffusion is most comparable to Cr and could operate via a vacancy-controlled mechanism.
Idioma: Inglés
DOI: 10.1007/s11669-019-00755-7
Año: 2019
Publicado en: JOURNAL OF PHASE EQUILIBRIA AND DIFFUSION 40, 5 (2019), 686-696
ISSN: 1547-7037

Factor impacto JCR: 1.315 (2019)
Categ. JCR: METALLURGY & METALLURGICAL ENGINEERING rank: 43 / 79 = 0.544 (2019) - Q3 - T2
Categ. JCR: CHEMISTRY, PHYSICAL rank: 139 / 158 = 0.88 (2019) - Q4 - T3
Categ. JCR: MATERIALS SCIENCE, MULTIDISCIPLINARY rank: 254 / 314 = 0.809 (2019) - Q4 - T3

Factor impacto SCIMAGO: 0.529 - Metals and Alloys (Q1) - Condensed Matter Physics (Q2) - Materials Chemistry (Q2)

Tipo y forma: Artículo (Versión definitiva)

Creative Commons Debe reconocer adecuadamente la autoría, proporcionar un enlace a la licencia e indicar si se han realizado cambios. Puede hacerlo de cualquier manera razonable, pero no de una manera que sugiera que tiene el apoyo del licenciador o lo recibe por el uso que hace. No puede utilizar el material para una finalidad comercial. Si remezcla, transforma o crea a partir del material, no puede difundir el material modificado.


Exportado de SIDERAL (2020-07-16-09:45:02)


Visitas y descargas

Este artículo se encuentra en las siguientes colecciones:
Artículos



 Registro creado el 2019-12-12, última modificación el 2020-07-16


Versión publicada:
 PDF
Valore este documento:

Rate this document:
1
2
3
 
(Sin ninguna reseña)