Oxy-co-Firing in Fluidized Beds: Control of Sulfur Emissions and Assessment of Corrosion Issues
Resumen: The main objective of this work is to experimentally analyse the effect of firing blends of coal and biomass in oxy-firing atmospheres on SO2 emissions and deposition/corrosion issues. The research has been conducted in a lab-scale fluidized bed unit, and chemical reactivity of deposited species has been simulated at bench scale. Two very different Spanish coals were selected for the oxy-combustion experiments: anthracite, with a very low volatile matter, and lignite with high sulphur content. As concerns the biomass, a short campaign was conducted with forest residues, but most effort was done firing corn stover (with three different chlorine levels). The experimental matrix was designed to analyse the effects of the following parameters: atmosphere (air vs. O2/CO2), coal-to-biomass ratio in the blend (90/10% vs. 80/20%) and bed temperature (850-900 °C). Control of SO2 emissions was largely dependent on the governing desulfurization mechanism, while chlorine in the biomass plays a role in the condensed alkali sulfates. No significant deposition rates were detected even for the higher biomass shares in the blend (20%). Only when corn stover with the highest chlorine content (2%) was fired, a thick deposition scale was found. For the original corn stover, oxy-firing barely affects the deposition rate and slightly reduces the corrosion risk in comparison to conventional air-firing.
Idioma: Inglés
DOI: 10.1016/j.egypro.2017.03.1735
Año: 2017
Publicado en: Energy procedia 114 (2017), 6003-6009
ISSN: 1876-6102

Factor impacto SCIMAGO:

Financiación: info:eu-repo/grantAgreement/ES/MINECO/ENE2012-39114
Tipo y forma: Artículo (Versión definitiva)
Área (Departamento): Máquinas y Motores Térmicos (Departamento de Ingeniería Mecánica)

Creative Commons Debe reconocer adecuadamente la autoría, proporcionar un enlace a la licencia e indicar si se han realizado cambios. Puede hacerlo de cualquier manera razonable, pero no de una manera que sugiera que tiene el apoyo del licenciador o lo recibe por el uso que hace. No puede utilizar el material para una finalidad comercial. Si remezcla, transforma o crea a partir del material, no puede difundir el material modificado.


Exportado de SIDERAL (2018-04-11-11:56:16)

Este artículo se encuentra en las siguientes colecciones:
Artículos > Artículos por área > Máquinas y Motores Térmicos



 Registro creado el 2018-04-11, última modificación el 2018-04-11


Versión publicada:
 PDF
Valore este documento:

Rate this document:
1
2
3
 
(Sin ninguna reseña)