Solid-state preparation of metal and metal oxides nanostructures and their application in environmental remediation
Resumen: Nanomaterials have attracted much attention over the last decades due to their very different properties compared to those of bulk equivalents, such as a large surface-to-volume ratio, the size-dependent optical, physical, and magnetic properties. A number of solution fabrication methods have been developed for the synthesis of metal and metal oxides nanoparticles, but few solid-state methods have been reported. The application of nanostructured materials to electronic solid-state devices or to high-temperature technology requires, however, adequate solid-state methods for obtaining nanostructured materials. In this review, we discuss some of the main current methods of obtaining nanomaterials in solid state, and also we summarize the obtaining of nanomaterials using a new general method in solid state. This new solid-state method to prepare metals and metallic oxides nanostructures start with the preparation of the macromolecular complexes chitosan center dot Xn and PS-co-4-PVP center dot MXn as precursors (X = anion accompanying the cationic metal, n = is the subscript, which indicates the number of anions in the formula of the metal salt and PS-co-4-PVP = poly(styrene-co-4-vinylpyridine)). Then, the solid-state pyrolysis under air and at 800 degrees C affords nanoparticles of M degrees, MxOy depending on the nature of the metal. Metallic nanoparticles are obtained for noble metals such as Au, while the respective metal oxide is obtained for transition, representative, and lanthanide metals. Size and morphology depend on the nature of the polymer as well as on the spacing of the metals within the polymeric chain. Noticeably in the case of TiO2, anatase or rutile phases can be tuned by the nature of the Ti salts coordinated in the macromolecular polymer. A mechanism for the formation of nanoparticles is outlined on the basis of TG/DSC data. Some applications such as photocatalytic degradation of methylene by different metal oxides obtained by the presented solid-state method are also described. A brief review of the main solid-state methods to prepare nanoparticles is also outlined in the introduction. Some challenges to further development of these materials and methods are finally discussed.
Idioma: Inglés
DOI: 10.3390/ijms23031093
Año: 2022
Publicado en: International Journal of Molecular Sciences 23, 3 (2022), 1093 [29 pp.]
ISSN: 1661-6596

Factor impacto JCR: 5.6 (2022)
Categ. JCR: BIOCHEMISTRY & MOLECULAR BIOLOGY rank: 66 / 285 = 0.232 (2022) - Q1 - T1
Categ. JCR: CHEMISTRY, MULTIDISCIPLINARY rank: 52 / 178 = 0.292 (2022) - Q2 - T1

Factor impacto CITESCORE: 7.8 - Biochemistry, Genetics and Molecular Biology (Q1) - Computer Science (Q1) - Chemistry (Q1) - Chemical Engineering (Q1) - Medicine (Q1)

Factor impacto SCIMAGO: 1.154 - Medicine (miscellaneous) (Q1) - Physical and Theoretical Chemistry (Q1) - Computer Science Applications (Q1) - Inorganic Chemistry (Q1) - Spectroscopy (Q1) - Organic Chemistry (Q1) - Molecular Biology (Q2) - Catalysis (Q2)

Financiación: info:eu-repo/grantAgreement/ES/AEI/PID2019-107106RB-C32
Tipo y forma: Review (Published version)
Exportado de SIDERAL (2024-03-18-13:48:25)


Visitas y descargas

Este artículo se encuentra en las siguientes colecciones:
articulos



 Notice créée le 2022-05-03, modifiée le 2024-03-19


Versión publicada:
 PDF
Évaluer ce document:

Rate this document:
1
2
3
 
(Pas encore évalué)