Energy Self-Sufficiency Urban Module (ESSUM): GIS-LCA-based multi-criteria methodology to analyze the urban potential of solar energy generation and its environmental implications
Resumen: The concentration of the population in cities has turned them into sources of environmental pollution, however, cities have a great potential for generating clean energy through renewable sources such as a responsible use of solar energy that reaches its rooftops. This work proposes a methodology to estimate the level of energy self-sufficiency in urban areas, particularly in a district of the city of Zaragoza (Spain). First, the Energy Self-Sufficiency Urban Module concept (ESSUM) is defined, then the self-sufficiency capacity of the city or district is determined using Geographical Information Systems (GIS), Light Detection and Ranging (LiDAR) point clouds and cadastral data. Secondly, the environmental implications of the implementation of these modules in the rooftops of the city using the LCA methodology are calculated. The results obtained show that total self-sufficiency of Domestic Hot Water (DHW) can be achieved using 21 % of available rooftop area, meanwhile the rest of rooftop area, dedicated to photovoltaic (PV), can reach 20 % of electricity self-sufficiency, supposing a final balance of a reduction in CO2 emissions of 12,695.4 t CO2eq/y and energy savings of 372,468.5 GJ/y. This corresponds to a scenario where full self-sufficiency of DHW was prioritized, with the remaining roof area dedicated to PV installation. In addition, other scenarios have been analyzed, such as the implementation of the energy systems separately.
Idioma: Inglés
DOI: 10.1016/j.scitotenv.2023.163077
Año: 2023
Publicado en: SCIENCE OF THE TOTAL ENVIRONMENT 879 (2023), 163077 [15 pp.]
ISSN: 0048-9697

Factor impacto JCR: 8.2 (2023)
Categ. JCR: ENVIRONMENTAL SCIENCES rank: 31 / 358 = 0.087 (2023) - Q1 - T1
Factor impacto CITESCORE: 17.6 - Pollution (Q1) - Environmental Engineering (Q1) - Waste Management and Disposal (Q1) - Environmental Chemistry (Q1)

Factor impacto SCIMAGO: 1.998 - Environmental Chemistry (Q1) - Waste Management and Disposal (Q1) - Pollution (Q1) - Environmental Engineering (Q1)

Financiación: info:eu-repo/grantAgreement/ES/MICINN/RYC2021-034265-I
Financiación: info:eu-repo/grantAgreement/ES/UZ/UZ2020-TEC-07
Tipo y forma: Article (Published version)
Área (Departamento): Área Construc. Arquitectónicas (Dpto. Arquitectura)
Área (Departamento): Área Expresión Gráfica en Ing. (Dpto. Ingeniería Diseño Fabri.)
Área (Departamento): Área Máquinas y Motores Térmi. (Dpto. Ingeniería Mecánica)
Área (Departamento): Área Urbanística y Ord.Territ. (Dpto. Arquitectura)
Área (Departamento): Área Análisis Geográfico Regi. (Dpto. Geograf. Ordenac.Territ.)


Creative Commons You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.


Exportado de SIDERAL (2024-11-22-11:59:15)


Visitas y descargas

Este artículo se encuentra en las siguientes colecciones:
Articles > Artículos por área > Urbanística y Ordenación del Territorio
Articles > Artículos por área > Expresión Gráfica de la Ingeniería
Articles > Artículos por área > Construcciones Arquitectónicas
Articles > Artículos por área > Análisis Geográfico Regional
Articles > Artículos por área > Máquinas y Motores Térmicos



 Record created 2023-06-02, last modified 2024-11-25


Versión publicada:
 PDF
Rate this document:

Rate this document:
1
2
3
 
(Not yet reviewed)