Effect of Sr substitution for Ca on the Ca3Co4O 9 thermoelectric properties

Constantinescu, G. ; Rasekh, Sh. ; Torres, M.A. (Universidad de Zaragoza) ; Diez, J.C. (Universidad de Zaragoza) ; Madre, M.A. (Universidad de Zaragoza) ; Sotelo, A. (Universidad de Zaragoza)
Effect of Sr substitution for Ca on the Ca3Co4O 9 thermoelectric properties
Resumen: Ca3−xSrxCo4O9 polycrystalline thermoelectric ceramics with small amounts of Sr have been synthesized by the classical solid state method. Microstructural characterizations have shown that all the Sr has been incorporated into the Ca3Co4O9 and Ca3Co2O6 structures and no Sr-based secondary phases have been produced. Apparent density measurements have shown that samples slightly increase their density until 0.05 Sr content, decreasing for higher contents. Electrical resistivity decreases and Seebeck coefficient slightly raises when Sr content increases until 0.07 Sr addition. The improvement in both parameters leads to higher power factor values than the usually obtained in samples prepared by the conventional solid state routes and close to those obtained in textured materials.
Idioma: Inglés
Año: 2013
Publicado en: JOURNAL OF ALLOYS AND COMPOUNDS 577 (2013), 511-515
ISSN: 0925-8388

Factor impacto JCR: 2.726 (2013)
Categ. JCR: MATERIALS SCIENCE, MULTIDISCIPLINARY rank: 49 / 246 = 0.199 (2013) - Q1 - T1
Categ. JCR: METALLURGY & METALLURGICAL ENGINEERING rank: 5 / 75 = 0.067 (2013) - Q1 - T1
Categ. JCR: CHEMISTRY, PHYSICAL rank: 53 / 134 = 0.396 (2013) - Q2 - T2

Financiación: info:eu-repo/grantAgreement/ES/DGA/T12
Financiación: info:eu-repo/grantAgreement/ES/DGA/T87
Tipo y forma: Artículo (PostPrint)
Área (Departamento): Área Expresión Gráfica en Ing. (Dpto. Ingeniería Diseño Fabri.)
Área (Departamento): Área Cienc.Mater. Ingen.Metal. (Dpto. Ciencia Tecnol.Mater.Fl.)


Creative Commons Debe reconocer adecuadamente la autoría, proporcionar un enlace a la licencia e indicar si se han realizado cambios. Puede hacerlo de cualquier manera razonable, pero no de una manera que sugiera que tiene el apoyo del licenciador o lo recibe por el uso que hace. No puede utilizar el material para una finalidad comercial. Si remezcla, transforma o crea a partir del material, no puede difundir el material modificado.


Exportado de SIDERAL (2026-01-26-14:49:34)


Visitas y descargas

Este artículo se encuentra en las siguientes colecciones:
Artículos > Artículos por área > Ciencia de los Materiales e Ingeniería Metalúrgica
Artículos > Artículos por área > Expresión Gráfica de la Ingeniería



 Registro creado el 2026-01-26, última modificación el 2026-01-26


Postprint:
 PDF
Valore este documento:

Rate this document:
1
2
3
 
(Sin ninguna reseña)