Fabrication of an additive manufactured mould for the production of a drone engine cover using the infusion composites process

Martin Compaired, Clara Luna (Universidad de Zaragoza) ; Ranz Angulo, David (Universidad de Zaragoza) ; Gomez Garcia, Jose Antonio (Universidad de Zaragoza) ; Miralbés Buil, Ramón (Universidad de Zaragoza) ; Tsegaye, Lemmi ; Barburski, Marcin

Resumen: Metal moulds have historically been employed in the fabrication of composite components. The primary drawbacks associated with this method of mould fab-rication include the substantial time investment required and the significant ex-pense, which necessitates amortisation only when manufacturing large quanti-ties of a component. As an alternative, we propose the utilisation of moulds fab-ricated by fused deposition modelling (FDM) technique. The primary benefit of this technology is their accessibility, which facilitates their localised manufactur-ing in a significantly reduced timeframe. This renders them well-suited for the fabrication of moulds for composite components in limited production runs. Moreover, the utilisation of biodegradable materials derived from renewable sources during manufacturing processes enables the creation of moulds in a more sustainable manner. In this case study, the computer-aided design (CAD) process and manufacture of a mould using FDM for the production of a cover for a drone engine is presented. The design phases and requirements are out-lined, and the challenges encountered during the process are discussed. The in-fusion process is conducted using sustainable materials such as flax and bio-epoxy resin. The final result of this process is the engine casing, which is com-posed of the aforementioned materials as part of the Sustainable Industrial De-sign of Textile Structures for Composites European project (SustDesignTex). In conclusion, the utilisation of FDM technology facilitates the manufacture of polylactic acid (PLA) moulds for small series of parts in a more accessible and economical way compared to costly conventional methodologies. The most no-table result of the study was that the curing of the resin should not exceed 40°C, as exceeding this temperature results in mould deformations, shortening its lifespan.

Idioma: Inglés

DOI: 10.52152/D11492

Año: 2026

Publicado en: Dyna (Bilbao) 101, 1 (2026), 63-68
ISSN: 0012-7361

Financiación: info:eu-repo/grantAgreement/EC/H2020/101079009/EU/SUSTainable industrial DESIGN of TEXtile structures for composites/SustDesignTex

Tipo y forma: Article (Published version)

Área (Departamento): Área Expresión Gráfica en Ing. (Dpto. Ingeniería Diseño Fabri.)
Área (Departamento): Área Técnica. Lab. y Talleres (Dpto. Ingeniería Diseño Fabri.)