Resumen: Bi2-xPbxBa2Co2Oy (x=0.0, 0.2, 0.4, and 0.6) misfit compounds were grown by the laser floating zone technique. Microstructural analysis has shown the formation of thermoelectric grains together with high amount of secondary phases. Thermoelectric grains orientation is increased until 0.4Pb, while further substitution drastically destroys the preferential grain orientation. Electrical resistivity is very low compared with the values obtained in sintered materials, spectacularly increasing power factor. Moreover, the performance of these materials was further improved subjecting the as-grown samples to a postannealing step due to the rise of thermoelectric phase content. These microstructural modifications led to a high decrease of electrical resistivity, improving power factor in around a factor two at room temperature, compared with the as-grown samples. Moreover, the low thermal conductivity of the textured annealed samples leads to a maximum estimated ZT value of 0.53 for the 0.2 Pb-doped samples, much higher than the reported in literature.
Idioma: Inglés
DOI: 10.1016/j.jeurceramsoc.2015.09.034
Año: 2016
Publicado en: Journal of the European Ceramic Society 36, 1 (2016), 67-74
ISSN: 0955-2219

Factor impacto JCR: 3.411 (2016)
Categ. JCR: MATERIALS SCIENCE, CHARACTERIZATION & TESTING rank: 1 / 26 = 0.038 (2016) - Q1 - T1
Categ. JCR: MATERIALS SCIENCE, CERAMICS rank: 1 / 26 = 0.038 (2016) - Q1 - T1

Factor impacto SCIMAGO: 1.141 - Materials Chemistry (Q1) - Ceramics and Composites (Q1)

Financiación: info:eu-repo/grantAgreement/ES/DGA/T12
Financiación: info:eu-repo/grantAgreement/ES/DGA/T87
Financiación: info:eu-repo/grantAgreement/ES/MINECO/MAT2013-46505-C3-1-R
Tipo y forma: Artículo (PrePrint)
Área (Departamento): Área Cienc.Mater. Ingen.Metal. (Dpto. Ciencia Tecnol.Mater.Fl.)

Creative Commons Debe reconocer adecuadamente la autoría, proporcionar un enlace a la licencia e indicar si se han realizado cambios. Puede hacerlo de cualquier manera razonable, pero no de una manera que sugiera que tiene el apoyo del licenciador o lo recibe por el uso que hace. No puede utilizar el material para una finalidad comercial. Si remezcla, transforma o crea a partir del material, no puede difundir el material modificado.


Exportado de SIDERAL (2023-12-21-13:40:39)


Visitas y descargas

Este artículo se encuentra en las siguientes colecciones:
Artículos



 Registro creado el 2015-12-23, última modificación el 2023-12-21


Preprint:
 PDF
Valore este documento:

Rate this document:
1
2
3
 
(Sin ninguna reseña)