Study of the polycarbonate-urethane/metal contact in different positions during gait cycle
Resumen: Nowadays, a growing number of young andmore active patients receive hip replacement.More strenuous activities in such patients involve higher friction and wear rates, with friction on the bearing surface being crucial to ensure arthroplasty survival in the long term. Over the last years, the polycarbonate-urethane has offered a feasible alternative to conventional bearings. A finite element model of a healthy hip joint was developed and adjusted to three gait phases (heel strike, mid-stance, and toe-off), serving as a benchmark for the assessment of the results of joint replacement model. Three equivalent models were made with the polycarbonate-urethane Tribofit system implanted, one for each of the three gait phases, after reproducing a virtual surgery over the respective healthy models. Standard body-weight loads were considered: 230% body-weight toe-off, 275% body-weight mid-stance, and 350% body-weight heel strike. Contact pressures were obtained for the different models. When comparing the results corresponding to the healthy model to polycarbonate-urethane joint, contact areas are similar and so contact pressures are within a narrower value range. In conclusion, polycarbonate-urethane characteristics are similar to those of the joint cartilage. So, it is a favorable alternative to traditional bearing surfaces in total hip arthroplasty, especially in young patients.
Idioma: Inglés
DOI: 10.1155/2014/548968
Año: 2014
Publicado en: BioMed Research International 2014, 548968 (2014), [11 pp]
ISSN: 2314-6133

Factor impacto JCR: 1.579 (2014)
Categ. JCR: MEDICINE, RESEARCH & EXPERIMENTAL rank: 85 / 123 = 0.691 (2014) - Q3 - T3
Categ. JCR: BIOTECHNOLOGY & APPLIED MICROBIOLOGY rank: 107 / 163 = 0.656 (2014) - Q3 - T2

Tipo y forma: Article (Published version)
Área (Departamento): Área Traumatología y Ortopedia (Dpto. Cirugía,Ginecol.Obstetr.)

Creative Commons You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.


Exportado de SIDERAL (2019-05-09-14:49:07)

Este artículo se encuentra en las siguientes colecciones:
Articles



 Record created 2016-12-16, last modified 2019-05-09


Versión publicada:
 PDF
Rate this document:

Rate this document:
1
2
3
 
(Not yet reviewed)