Resumen: This paper proposes the use of a transmitter based on a linear amplification with nonlinear components (LINC) architecture, in which the reconfigurable matching networks (RMNs) are included. By varying the RMN active cell number, it is possible to change the load impedance at the power amplifier (PA) output, improving the amplifier drain efficiency and therefore the efficiency of the whole system. A long-term evolution (LTE) downlink signal with a bandwidth of 1.4 MHz and a peak-to-average power ratio (PAPR) of 11.48 dB is applied in order to carry out the experiments. Results show that the use of the RMNs in a LINC architecture improves the efficiency at all tested frequencies, especially at 927 MHz reaching an enhancement of 36.50%. Regarding the distortion, the adjacent channel leakage ratio (ACLR) values increase in all cases, with an improvement of 3.5 dB at 958 MHz. Finally, in terms of error vector magnitude (EVM), the proposed architecture offers a value of 1.96% at 927 MHz. Idioma: Inglés DOI: 10.1186/s13638-017-0873-8 Año: 2017 Publicado en: EURASIP Journal on Wireless Communications and Networking 2017, 1 (2017), 90 [7 pp] ISSN: 1687-1472 Factor impacto JCR: 2.407 (2017) Categ. JCR: TELECOMMUNICATIONS rank: 35 / 87 = 0.402 (2017) - Q2 - T2 Categ. JCR: ENGINEERING, ELECTRICAL & ELECTRONIC rank: 98 / 260 = 0.377 (2017) - Q2 - T2 Factor impacto SCIMAGO: 0.301 - Computer Networks and Communications (Q2) - Signal Processing (Q3) - Computer Science Applications (Q3)