000006195 001__ 6195 000006195 005__ 20190220130407.0 000006195 037__ $$aTAZ-PFC-2011-385 000006195 041__ $$aeng 000006195 1001_ $$aNaudín Aparicio, Blanca 000006195 24500 $$aWind mill technology 000006195 260__ $$aZaragoza$$bUniversidad de Zaragoza$$c2011 000006195 500__ $$a“The aim of this project is to build a model which controls the electrical power from a wind mill. When the generator is connected to the grid, the generator shall deliver constant power. The rotor is through a power electronic circuit and a transformer connected to the grid. A power electronic circuit controls the induction generator slip. Power, voltage, current and speed are measured through transducers. A digital signal processor is controlling the system.” “This project is dealing with control, regulation and supervision of electrical power from a wind mill. The electrical power from the wind mill must be constant with use of “slip regulation” The wind mill generator, which is an induction machine with wound-rotor, is electrically connected with at “stiff” electrical power grid. The wind mill generator is mechanical connected with a dynamometer. The dynamometer is the primary mover.” 000006195 506__ $$aby-nc-sa$$bCreative Commons$$c3.0$$uhttp://creativecommons.org/licenses/by-nc-sa/3.0/ 000006195 520__ $$aEl objetivo del projecto es construir un modelo que controle la generación de electricidad en un aerogenerador. 000006195 521__ $$aIngeniero Técnico Industrial (Esp. Electricidad) 000006195 540__ $$aDerechos regulados por licencia Creative Commons 000006195 700__ $$aSteenbuch Vester, Heiko$$edir. 000006195 7102_ $$aUniversidad de Zaragoza$$bIngeniería Eléctrica$$cIngeniería Eléctrica 000006195 830__ $$aEUITIZ 000006195 8560_ $$f550512@celes.unizar.es 000006195 8564_ $$s2496494$$uhttps://zaguan.unizar.es/record/6195/files/TAZ-PFC-2011-385.pdf$$yMemoria (eng) 000006195 909CO $$ooai:zaguan.unizar.es:6195$$pdriver$$pproyectos-fin-carrera 000006195 950__ $$a 000006195 980__ $$aTAZ$$bPFC$$cEUITIZ