TAZ-PFC-2011-385


Wind mill technology

Naudín Aparicio, Blanca
Steenbuch Vester, Heiko (dir.)

Universidad de Zaragoza, EUITIZ, 2011
Ingeniería Eléctrica department, Ingeniería Eléctrica area

Ingeniero Técnico Industrial (Esp. Electricidad)

Abstract: El objetivo del projecto es construir un modelo que controle la generación de electricidad en un aerogenerador.

Tipo de Trabajo Académico: Proyecto Fin de Carrera
Notas: “The aim of this project is to build a model which controls the electrical power from a wind mill. When the generator is connected to the grid, the generator shall deliver constant power. The rotor is through a power electronic circuit and a transformer connected to the grid. A power electronic circuit controls the induction generator slip. Power, voltage, current and speed are measured through transducers. A digital signal processor is controlling the system.” “This project is dealing with control, regulation and supervision of electrical power from a wind mill. The electrical power from the wind mill must be constant with use of “slip regulation” The wind mill generator, which is an induction machine with wound-rotor, is electrically connected with at “stiff” electrical power grid. The wind mill generator is mechanical connected with a dynamometer. The dynamometer is the primary mover.”

Creative Commons License

El registro pertenece a las siguientes colecciones:
Academic Works > Trabajos Académicos por Centro > escuela-de-ingenieria-tecnica-industrial-de-zaragoza
Academic Works > Final Degree Projects




Rate this document:

Rate this document:
1
2
3
 
(Not yet reviewed)