| TAZ-PFC-2011-385 |
Wind mill technology
Naudín Aparicio, Blanca
Steenbuch Vester, Heiko (dir.)
Universidad de Zaragoza,
EUITIZ,
2011
Ingeniería Eléctrica department, Ingeniería Eléctrica area
Ingeniero Técnico Industrial (Esp. Electricidad)
Tipo de Trabajo Académico: Proyecto Fin de Carrera
Notas: “The aim of this project is to build a model which controls the electrical power from a wind mill. When the generator is connected to the grid, the generator shall deliver constant power. The rotor is through a power electronic circuit and a transformer connected to the grid. A power electronic circuit controls the induction generator slip. Power, voltage, current and speed are measured through transducers. A digital signal processor is controlling the system.” “This project is dealing with control, regulation and supervision of electrical power from a wind mill. The electrical power from the wind mill must be constant with use of “slip regulation” The wind mill generator, which is an induction machine with wound-rotor, is electrically connected with at “stiff” electrical power grid. The wind mill generator is mechanical connected with a dynamometer. The dynamometer is the primary mover.”
Notas: “The aim of this project is to build a model which controls the electrical power from a wind mill. When the generator is connected to the grid, the generator shall deliver constant power. The rotor is through a power electronic circuit and a transformer connected to the grid. A power electronic circuit controls the induction generator slip. Power, voltage, current and speed are measured through transducers. A digital signal processor is controlling the system.” “This project is dealing with control, regulation and supervision of electrical power from a wind mill. The electrical power from the wind mill must be constant with use of “slip regulation” The wind mill generator, which is an induction machine with wound-rotor, is electrically connected with at “stiff” electrical power grid. The wind mill generator is mechanical connected with a dynamometer. The dynamometer is the primary mover.”
Permalink:
El registro pertenece a las siguientes colecciones:
trabajos-academicos-universidad-zaragoza > centro > escuela-de-ingenieria-tecnica-industrial-de-zaragoza
trabajos-academicos-universidad-zaragoza > proyectos-fin-carrera