Geometrical characterisation of a 2D laser system and calibration of a cross-grid encoder by means of a self-calibration methodology
Resumen: This article presents a self-calibration procedure and the experimental results for the geometrical characterisation of a 2D laser system operating along a large working range (50 mm × 50 mm) with submicrometre uncertainty. Its purpose is to correct the geometric errors of the 2D laser system setup generated when positioning the two laser heads and the plane mirrors used as reflectors. The non-calibrated artefact used in this procedure is a commercial grid encoder that is also a measuring instrument. Therefore, the self-calibration procedure also allows the determination of the geometrical errors of the grid encoder, including its squareness error. The precision of the proposed algorithm is tested using virtual data. Actual measurements are subsequently registered, and the algorithm is applied. Once the laser system is characterised, the error of the grid encoder is calculated along the working range, resulting in an expanded submicrometre calibration uncertainty (k = 2) for the X and Y axes. The results of the grid encoder calibration are comparable to the errors provided by the calibration certificate for its main central axes. It is, therefore, possible to confirm the suitability of the self-calibration methodology proposed in this article.
Idioma: Inglés
DOI: 10.3390/s17091992
Año: 2017
Publicado en: Sensors (Switzerland) 17, 9 (2017), [16 pp]
ISSN: 1424-8220

Factor impacto JCR: 2.475 (2017)
Categ. JCR: CHEMISTRY, ANALYTICAL rank: 30 / 80 = 0.375 (2017) - Q2 - T2
Categ. JCR: INSTRUMENTS & INSTRUMENTATION rank: 16 / 61 = 0.262 (2017) - Q2 - T1
Categ. JCR: ELECTROCHEMISTRY rank: 15 / 28 = 0.536 (2017) - Q3 - T2

Factor impacto SCIMAGO: 0.584 - Analytical Chemistry (Q2) - Atomic and Molecular Physics, and Optics (Q2) - Medicine (miscellaneous) (Q2) - Electrical and Electronic Engineering (Q2) - Instrumentation (Q2) - Biochemistry (Q3)

Financiación: info:eu-repo/grantAgreement/ES/MINECO/DPI2010-21629-C02-01
Financiación: info:eu-repo/grantAgreement/ES/MINECO/DPI2015-69403-C3-1-R
Financiación: info:eu-repo/grantAgreement/ES/UZ/CUD2016-TEC-09
Tipo y forma: Article (Published version)
Área (Departamento): Área Ing. Procesos Fabricación (Dpto. Ingeniería Diseño Fabri.)

Creative Commons You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.


Exportado de SIDERAL (2020-08-11-09:02:57)


Visitas y descargas

Este artículo se encuentra en las siguientes colecciones:
Articles



 Record created 2017-10-05, last modified 2020-08-11


Versión publicada:
 PDF
Rate this document:

Rate this document:
1
2
3
 
(Not yet reviewed)