A new calibration guideline for worm and worm-gear rolling testers
Pueo, M. ; Santolaria, J. (Universidad de Zaragoza) ; Acero, R. ; Aguado, S. (Universidad de Zaragoza) ; Gracia, A.
Resumen: The evaluation and calibration of gear testers are considered as a key point to ensure the obtained results in gear metrology. Although ISO TC 60 working group has developed standards in this regard, the fact is that for the time being, there are not specific international standards for gear rolling tests. In this work, a periodical calibration guideline for gear rolling testers, particularly for worm gear transmission, is proposed, allowing the reduction of possible error sources in the measurement process. A series of tasks distributed over time are suggested in this work to maintain the accuracy of the gear rolling test machines.
Idioma: Inglés
DOI: 10.1016/j.promfg.2017.09.119
Año: 2017
Publicado en: Procedia Manufacturing 13 (2017), 601-607
ISSN: 2351-9789
Factor impacto SCIMAGO: 0.201 - Industrial and Manufacturing Engineering (Q3) - Artificial Intelligence (Q3)
Tipo y forma: Article (Published version)
Área (Departamento): Proy. investigación HHA (Dpto. Ingeniería Diseño Fabri.)
Área (Departamento): Área Ing. Procesos Fabricación (Dpto. Ingeniería Diseño Fabri.)
You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use. You may not use the material for commercial purposes. If you remix, transform, or build upon the material, you may not distribute the modified material.
Exportado de SIDERAL (2019-07-09-12:09:23)
Visitas y descargas
Idioma: Inglés
DOI: 10.1016/j.promfg.2017.09.119
Año: 2017
Publicado en: Procedia Manufacturing 13 (2017), 601-607
ISSN: 2351-9789
Factor impacto SCIMAGO: 0.201 - Industrial and Manufacturing Engineering (Q3) - Artificial Intelligence (Q3)
Tipo y forma: Article (Published version)
Área (Departamento): Proy. investigación HHA (Dpto. Ingeniería Diseño Fabri.)
Área (Departamento): Área Ing. Procesos Fabricación (Dpto. Ingeniería Diseño Fabri.)
You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use. You may not use the material for commercial purposes. If you remix, transform, or build upon the material, you may not distribute the modified material. Exportado de SIDERAL (2019-07-09-12:09:23)
Permalink:
Visitas y descargas
Este artículo se encuentra en las siguientes colecciones:
Articles
Record created 2018-04-12, last modified 2019-07-09