Microfluidic devices as gas – Ionic liquid membrane contactors for CO2 removal from anaesthesia gases

Malankowska, M. ; Martins, C. F. ; Rho, H. S. ; Neves, L. A. ; Tiggelaar, R. M. ; Crespo, J. G. ; Pina, M. P. (Universidad de Zaragoza) ; Mallada, R. (Universidad de Zaragoza) ; Gardeniers, H. ; Coelhoso, I. M.

Resumen: This work proposes a microfluidic gas – ionic liquid contactor for CO2 removal from anaesthesia gas, containing Xe. The working principle involves the transport of CO2 through a polymer flat membrane followed by its capture and enzymatic bioconversion in the ionic liquid solvent. Microfluidic devices enable a rapid and inexpensive screening of potential CO2 absorbers. The alveolar – type design of the ionic liquid chamber was adopted to reduce mass transfer limitations of CO2 through the liquid phase. Polydimethylsiloxane (PDMS) was the chosen polymer for dense membrane, as well as for the microfluidic device fabrication, mainly due to the high permeability of gases, O2 and CO2, and low cost. The selected ionic liquid was cholinium propionate (CP) with a water activity of 0.753, due to its high affinity towards CO2 and biocompatibility with the enzyme used for CO2 conversion to bicarbonate, carbonic anhydrase (CA). The CO2 and Xe permeability and CO2/Xe selectivity were determined in the microfluidic devices developed and compared to those exhibited by free standing PDMS membranes mounted on a standard permeation cell. The performance of the microfluidic devices as gas – ionic liquid contactors was evaluated for a given solvent flow rate with pure gas streams of CO2 and Xe. The obtained results show that cholinium propionate with or without the enzyme has no effect on the Xe transport, but remarkably enhances the affinity towards carbon dioxide leading to enhancement factor up to 1.9 in the presence of 0.1 mg CA/gIL.

Idioma: Inglés

DOI: 10.1016/j.memsci.2017.09.065

Año: 2018

Publicado en: JOURNAL OF MEMBRANE SCIENCE 545 (2018), 107-115
ISSN: 0376-7388

Factor impacto JCR: 7.015 (2018)

Categ. JCR: POLYMER SCIENCE rank: 2 / 86 = 0.023 (2018) - Q1 - T1
Categ. JCR: ENGINEERING, CHEMICAL rank: 8 / 138 = 0.058 (2018) - Q1 - T1

Factor impacto SCIMAGO: 2.119 - Biochemistry (Q1) - Physical and Theoretical Chemistry (Q1) - Materials Science (miscellaneous) (Q1) - Filtration and Separation (Q1)

Financiación: info:eu-repo/grantAgreement/ES/DGA/EU-EACEA/SGA2012-1719
Financiación: info:eu-repo/grantAgreement/ES/FEDER/POCI-01-0145-007265

Tipo y forma: Article (PostPrint)

Área (Departamento): Área Ingeniería Química (Dpto. Ing.Quím.Tecnol.Med.Amb.)