Analysis of different camera calibration methods on a camera-projector measuring system
Tiscareño, Julieta ; Albajez García, José Antonio (Universidad de Zaragoza) ; Santolaria Mazo, Jorge (Universidad de Zaragoza)
Resumen: The accuracy of metrology equipment formed by a camera-projector pair depends directly on the calibration procedure used. This kind of equipment allows to perform the calibration by two different approaches: as a whole system or separately. The most common approach is the second one: conventional calibration. Studies show that the uncertainty of the camera parameters from its calibration propagates to the projector parameters. The objective of this study is to have a clear comprehension of the relationships between the camera and projector parameters and of how uncertainty is propagated. This will be done by using a camera previously calibrated by Tsai, Zhang or Direct Linear Calibration (DLC) methods, followed by the calibration of the projector using DLC.
Idioma: Inglés
DOI: 10.1016/j.promfg.2019.09.041
Año: 2019
Publicado en: Procedia Manufacturing 41 (2019), 539-546
ISSN: 2351-9789
Factor impacto SCIMAGO: 0.516 - Industrial and Manufacturing Engineering (Q2) - Artificial Intelligence (Q2)
Tipo y forma: Article (Published version)
Área (Departamento): Área Ing. Procesos Fabricación (Dpto. Ingeniería Diseño Fabri.)
You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use. You may not use the material for commercial purposes. If you remix, transform, or build upon the material, you may not distribute the modified material.
Exportado de SIDERAL (2023-09-21-13:30:29)
Visitas y descargas
Idioma: Inglés
DOI: 10.1016/j.promfg.2019.09.041
Año: 2019
Publicado en: Procedia Manufacturing 41 (2019), 539-546
ISSN: 2351-9789
Factor impacto SCIMAGO: 0.516 - Industrial and Manufacturing Engineering (Q2) - Artificial Intelligence (Q2)
Tipo y forma: Article (Published version)
Área (Departamento): Área Ing. Procesos Fabricación (Dpto. Ingeniería Diseño Fabri.)
You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use. You may not use the material for commercial purposes. If you remix, transform, or build upon the material, you may not distribute the modified material. Exportado de SIDERAL (2023-09-21-13:30:29)
Permalink:
Visitas y descargas
Este artículo se encuentra en las siguientes colecciones:
Articles
Record created 2020-08-06, last modified 2023-09-21