Detail investigation of thermoelectric performance and magnetic properties of Cs-doped Bi2Sr2Co2Oy ceramic materials
Resumen: Bi2Sr2-xCsxCo2Oy materials with 0 = x = 0.15, have been fabricated via the classical ceramic technique. XRD results have indicated that undoped and Cs-substituted samples are composed of Bi2Sr2Co2Oy phase as the major one. Microstructural studies have demonstrated the formation of a liquid phase, which allows a drastic grain growth. This factor is responsible for a drastic improvement of relative density, reaching about 95% of the theoretical one for 0.125 Cs content. On the other hand, electrical resistivity has been reduced up to 14 mO cm at 650 °C for 0.125 Cs content, around 40% lower than the obtained in undoped samples. As a consequence, Seebeck coefficient has been decreased due to the raise in charge carrier concentration. The highest power factor at 650 °C (0.21 mW/K2 m) has been found for 0.125 Cs substituted sample, about 40% larger than the obtained in undoped samples, and very similar to the notified in single crystals (0.26 mW/K2 m). Magnetisation with respect to temperature results have demonstrated that measured samples have a paramagnetic property above 50 K, except 0.10 Cs. Magnetic hysteresis curves have shown that the slopes and the magnitudes have increased with decreasing temperature.
Idioma: Inglés
DOI: 10.1007/s42452-020-04066-2
Año: 2021
Publicado en: SN Applied Sciences 3, 1 (2021), 114 [8 pp]
ISSN: 2523-3963

Factor impacto CITESCORE: 2.7 - Earth and Planetary Sciences (Q2) - Environmental Science (Q2) - Engineering (Q2) - Chemical Engineering (Q3) - Materials Science (Q3) - Physics and Astronomy (Q3)

Factor impacto SCIMAGO: 0.342 - Chemical Engineering (miscellaneous) (Q2) - Engineering (miscellaneous) (Q2) - Materials Science (miscellaneous) (Q2) - Physics and Astronomy (miscellaneous) (Q2) - Environmental Science (miscellaneous) (Q2)

Financiación: info:eu-repo/grantAgreement/ES/DGA/T54-17R
Financiación: info:eu-repo/grantAgreement/ES/MINECO-FEDER/MAT2017-82183-C3-1-R
Tipo y forma: Article (Published version)
Área (Departamento): Área Expresión Gráfica en Ing. (Dpto. Ingeniería Diseño Fabri.)
Área (Departamento): Área Cienc.Mater. Ingen.Metal. (Dpto. Ciencia Tecnol.Mater.Fl.)


Creative Commons You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.


Exportado de SIDERAL (2024-06-14-09:07:48)


Visitas y descargas

Este artículo se encuentra en las siguientes colecciones:
Articles > Artículos por área > Ciencia de los Materiales e Ingeniería Metalúrgica
Articles > Artículos por área > Expresión Gráfica de la Ingeniería



 Record created 2021-03-10, last modified 2024-06-14


Versión publicada:
 PDF
Rate this document:

Rate this document:
1
2
3
 
(Not yet reviewed)