Coupled Biomechanical Response of the Cornea Assessed by Non-Contact Tonometry. A Simulation Study

Ariza-Gracia, Miguel A. (Universidad de Zaragoza) ; Zurita, Jesus F. ; Piñero, David P. ; Rodriguez Matas, Jose F. (Universidad de Zaragoza) ; Calvo, Begoña (Universidad de Zaragoza)

Resumen: The mechanical response of the cornea subjected to a non-contact air-jet tonometry diagnostic test represents an interplay between its geometry, the corneal material behavior and the loading. The objective is to study this interplay to better understand and interpret the results obtained with a non-contact tonometry test. A patient-specific finite element model of a healthy eye, accounting for the load free configuration, was used. The corneal tissue was modeled as an anisotropic hyperelastic material with two preferential directions. Three different sets of parameters within the human experimental range obtained from inflation tests were considered. The influence of the IOP was studied by considering four pressure levels (10–28 mmHg) whereas the influence of corneal thickness was studied by inducing a uniform variation (300–600 microns). A Computer Fluid Dynamics (CFD) air-jet simulation de- termined pressure loading exerted on the anterior corneal surface. The maximum apex displacement showed a linear variation with IOP for all materials examined. On the contrary, the maximum apex displacement followed a cubic relation with corneal thickness. In addition, a significant sensitivity of the apical displacement to the corneal stiffness was also obtained. Explanation to this behavior was found in the fact that the cornea experiences bending when subjected to an air-puff loading, causing the anterior surface to work in compression whereas the posterior surface works in tension. Hence, collagen fibers located at the anterior surface do not contribute to load bearing. Non-contact tonometry devices give useful information that could be misleading since the corneal deformation is the result of the interaction between the mechanical properties, IOP, and geometry. Therefore, a non- contact tonometry test is not sufficient to evaluate their individual contribution and a complete in-vivo characterization would require more than one test to independently determine the membrane and bending corneal behavior.

Idioma: Inglés

DOI: 10.1371/journal.pone.0121486

Año: 2015

Publicado en: PloS one 10, 3 (2015), e0121486 [15 p]
ISSN: 1932-6203

Factor impacto JCR: 3.057 (2015)

Categ. JCR: MULTIDISCIPLINARY SCIENCES rank: 11 / 62 = 0.177 (2015) - Q1 - T1

Factor impacto SCIMAGO: 1.427 - Agricultural and Biological Sciences (miscellaneous) (Q1) - Medicine (miscellaneous) (Q1) - Biochemistry, Genetics and Molecular Biology (miscellaneous) (Q1)

Financiación: info:eu-repo/grantAgreement/EC/FP7/606634/EU/Development of corneal biomechanical model. Dynamic topographical characterization based on 3D plenoptic imaging/POPCORN
Financiación: info:eu-repo/grantAgreement/ES/MINECO/DPI2011-27939-C02-01

Tipo y forma: Article (Published version)

Área (Departamento): Área Mec.Med.Cont. y Teor.Est. (Dpto. Ingeniería Mecánica)