Effect of syngas composition on the combustion and emissions characteristics of a syngas/diesel RCCI engine
Resumen: Reactivity controlled compression ignition (RCCI) strategy uses two different fuels with different reactivities which provides more control over the combustion process and has the potential to dramatically lower combustion temperature and NOX and PM emissions. The objective of the present study is to numerically investigate the impact of syngas composition on the combustion and emissions characteristics of an RCCI engine operating with syngas/diesel at constant energy per cycle. For this purpose, different syngas compositions produced through gasification process have been chosen for comparison with the simulated syngas (mixture of hydrogen and carbon monoxide). The results obtained indicate that using syngas results in more soot, CO and UHC emissions compared with simulated syngas. Even though more NOX reduction can be achieved while operating with syngas, the engine could suffer from poor combustion and misfire at low loads due to the presence of nitrogen in the mixture. In terms of exergy, both syngas mixtures lead to more exergy destruction by the increase of syngas substitution. Nevertheless, the magnitude of exergy destruction for simulated syngas is less than the normal syngas.
Idioma: Inglés
DOI: 10.3390/en13010212
Año: 2020
Publicado en: Energies 13, 1 (2020), 212 [19 pp]
ISSN: 1996-1073

Factor impacto JCR: 3.004 (2020)
Categ. JCR: ENERGY & FUELS rank: 70 / 114 = 0.614 (2020) - Q3 - T2
Factor impacto SCIMAGO: 0.597 - Control and Optimization (Q2) - Electrical and Electronic Engineering (Q2) - Renewable Energy, Sustainability and the Environment (Q2) - Energy Engineering and Power Technology (Q2) - Fuel Technology (Q2) - Energy (miscellaneous) (Q2)

Tipo y forma: Artículo (Versión definitiva)
Área (Departamento): Área Cienc.Mater. Ingen.Metal. (Dpto. Ciencia Tecnol.Mater.Fl.)

Creative Commons Debe reconocer adecuadamente la autoría, proporcionar un enlace a la licencia e indicar si se han realizado cambios. Puede hacerlo de cualquier manera razonable, pero no de una manera que sugiera que tiene el apoyo del licenciador o lo recibe por el uso que hace.


Exportado de SIDERAL (2021-09-02-09:08:43)


Visitas y descargas

Este artículo se encuentra en las siguientes colecciones:
Artículos > Artículos por área > Ciencia de los Materiales e Ingeniería Metalúrgica



 Registro creado el 2020-10-23, última modificación el 2021-09-02


Versión publicada:
 PDF
Valore este documento:

Rate this document:
1
2
3
 
(Sin ninguna reseña)