Induction heating of two magnetically independent loads with a single transmitter

Plumed, E. ; Lope, I. (Universidad de Zaragoza) ; Acero, J. (Universidad de Zaragoza) ; Burdío, J. M. (Universidad de Zaragoza)

Resumen: This article introduces the design of a system capable of heating two magnetically independent ferromagnetic loads placed on different horizontal planes, which uses a combination of induction heating and inductive coupling, called inductively coupled heating. The system uses a single primary inductor acting as a transmitter to transfer power to a secondary inductor attached to the bottom load, which is connected electrically with a third inductor that heats the top load. Since power of the whole system is supplied by a simple half-bridge inverter, the ratio of the delivered power to each of the loads, which is critical for cooking results, is entirely dependent on the system's geometry, coil's number of turns, and compensation capacitors. A finite-element model is used to simulate the magnetic fields generated by inductor currents and calculate the impedance matrix. With the impedance, capacitor values and inductors’ number of turns are selected with the objective of achieving a high power ratio between the top and bottom zones, as well as minimizing stress in the electronics. First, a prototype was built to validate the impedance results in the small-signal regime, and then, the full power regime was used to verify power and current simulations

Idioma: Inglés

DOI: 10.1109/TPEL.2021.3117146

Año: 2022

Publicado en: IEEE Transactions on Power Electronics 37, 3 (2022), 3391-3402
ISSN: 0885-8993

Factor impacto JCR: 6.7 (2022)

Categ. JCR: ENGINEERING, ELECTRICAL & ELECTRONIC rank: 42 / 274 = 0.153 (2022) - Q1 - T1

Factor impacto CITESCORE: 14.1 - Engineering (Q1)

Factor impacto SCIMAGO: 3.341 - Electrical and Electronic Engineering (Q1)

Financiación: info:eu-repo/grantAgreement/ES/MICINN/PID2019-103939RB-I00

Tipo y forma: Article (PostPrint)

Área (Departamento): Área Tecnología Electrónica (Dpto. Ingeniería Electrón.Com.)
Área (Departamento): Área Electromagnetismo (Dpto. Física Aplicada)